i have a husqvarna 350 chainsaw and were the sparkplug goes in the engine the threads are stripped how to fix?

how can i fix it

Comments

3 Responses to “i have a husqvarna 350 chainsaw and were the sparkplug goes in the engine the threads are stripped how to fix?”
  1. Dude says:
    March 22, 2010 at 2:31 pm

    Take your spark plug and go to your local auto parts store. Tell them you need a Heli Coil. Or if you have a good mechanic or engine re builder around, you could ask them.

  2. b123153h says:
    March 22, 2010 at 2:31 pm

    go to a parts store and buy a spark plug heli coil kit with threader tool and speedy coil and install new threads the kit comes with instructions and you need to use a Special lock tight to tighten the speedy coil in place. take your plug with you so you get the right coil and drill bit. before drilling put cylinder at top push rag inside and drill out old threads and put in new heli coil with heli coil kit.

  3. Steve says:
    October 4, 2010 at 4:04 am

    I broke the throttle trigger on a husqvarna 350. I know how to get the replacement part, but I don’t know how to seperate the plastic around the trigger so that I can remove it and put a new one in. I am afraid that if I pry it apart, it will break and I’ll need to buy the whole handle unit. Any advice?


 
Powered by WordPress Lab