Lubing my Husqvarna chainsaw.?

How much bar and chain lube do I put in?

Comments

4 Responses to “Lubing my Husqvarna chainsaw.?”
  1. Justin A says:
    August 6, 2009 at 10:02 pm

    fill up the oil compartment located on front of saw closest to the bar and chain and fill up the gas tank with the 50:1 gas oil mix the oiler should be set from the factory to run out of gas before you run out of bar oil

  2. Joe Rightmire says:
    August 6, 2009 at 10:02 pm

    There is a tank on the same side as the fuel tank, but on the bar end Fill the tank full every time you fill with fuel. FYI, most Husqvana saw run on a fuel mixture of 40-1.

  3. Jigi says:
    August 6, 2009 at 10:02 pm

    You usually fill the reservoir every time you fill up the fuel tank on all chainsaws. For the product manual for your model go to this link: http://www.usa.husqvarna.com/support_manual_search.aspx

  4. Keith S says:
    August 6, 2009 at 10:02 pm

    a mix of 40-1 will do the trick

Leave An Answer

Tell us what you're thinking about this question...
and oh, if you want a pic to show with your comment, go get a gravatar!

Powered by WordPress Lab