http://www.chainsawexpress.com/should-the-ignition-module-touch-the-flywheel-in-a-husqvarna-50-chainsaw Mon, 06 Sep 2010 21:38:29 +0000 http://wordpress.org/?v=2.9.2 hourly 1 http://www.chainsawexpress.com/should-the-ignition-module-touch-the-flywheel-in-a-husqvarna-50-chainsaw/comment-page-1#comment-409 Todd B Sat, 27 Jun 2009 14:41:37 +0000 http://www.chainsawexpress.com/should-the-ignition-module-touch-the-flywheel-in-a-husqvarna-50-chainsaw#comment-409 No, there should be an air gap of no more then .010". Take an index card and fold it in half. Then pull the module away from the flywheel and tighten the screws. Take the card and stick it between the module and the flywheel. Rotate the flywheel so the magnet is in front of the card and module. Loosen the screws, the magnet will draw the module to it, then the tighten the screws down, then rotate the magnet away and remove the card. No, there should be an air gap of no more then .010". Take an index card and fold it in half. Then pull the module away from the flywheel and tighten the screws. Take the card and stick it between the module and the flywheel. Rotate the flywheel so the magnet is in front of the card and module. Loosen the screws, the magnet will draw the module to it, then the tighten the screws down, then rotate the magnet away and remove the card.

]]> http://www.chainsawexpress.com/should-the-ignition-module-touch-the-flywheel-in-a-husqvarna-50-chainsaw/comment-page-1#comment-410 Pagrus Sat, 27 Jun 2009 14:41:37 +0000 http://www.chainsawexpress.com/should-the-ignition-module-touch-the-flywheel-in-a-husqvarna-50-chainsaw#comment-410 should have about 1 mm clearance should have about 1 mm clearance

]]>